CCNA practice test
10 questions per round from the 25-question free bank, weighted toward your weaker topics and questions you have not seen recently.
Loading practice…
Practice by topic
- Network Fundamentals 20%
- Network Access 20%
- IP Connectivity 25%
- IP Services 10%
- Security Fundamentals 15%
- Automation and Programmability 10%
Free CCNA practice exam questions, answers explained
About these questions
25 of the free questions have their own page with the correct answer, why each other choice is wrong, and the primary source it was checked against. They are original items written against Cisco Systems's published blueprint, not recalled exam questions.
Network Fundamentals (20% of the CCNA)
- What is the network address for host 172.16.45.200 with a /20 mask?
- How many usable host addresses are in a /31 subnet on a point-to-point link, and why?
- Which address is in a private range defined by RFC 1918?
- A network engineer captures traffic and sees a three-way handshake before data transfer. Which transport protocol and characteristic does this indicate?
- Which IPv6 address type is automatically configured on every IPv6-enabled interface and is required for neighbor discovery?
Network Access (20% of the CCNA)
- Two switches are connected by an 802.1Q trunk. Switch A has native VLAN 1, switch B has native VLAN 99. What is the result?
- Four switches run Rapid PVST+ with default priority. Which switch becomes the root bridge?
- An engineer configures channel-group 1 mode active on switch A and channel-group 1 mode auto on switch B. What happens?
- On which type of port should PortFast be enabled?
- In a Cisco lightweight wireless architecture, which protocol carries control and data between an AP and the WLC?
IP Connectivity (25% of the CCNA)
- A router has routes O 10.1.0.0/16 via A (AD 110) and S 10.1.4.0/22 via B (AD 1). Where does it send a packet to 10.1.5.7?
- Which command configures a floating static default route on a Cisco router that is used only if the OSPF-learned default route disappears?
- On a multi-access Ethernet segment running OSPFv2, which router becomes the DR by default?
- Two routers on the same link show OSPF neighbor state stuck in EXSTART. Which problem is the most likely cause?
- In the output 'S* 0.0.0.0/0 [1/0] via 198.51.100.1', what do the values 1 and 0 in brackets represent?
- What is the purpose of HSRP?
IP Services (10% of the CCNA)
- Host 192.168.1.10 sits behind a router that translates it to 203.0.113.5 when reaching server 198.51.100.7. In NAT terminology, 203.0.113.5 is the:
- Which syslog severity level corresponds to 'warnings'?
- Clients on VLAN 20 cannot get addresses from a DHCP server on another subnet. Which configuration on the VLAN 20 router interface fixes this?
Security Fundamentals (15% of the CCNA)
- Which ACL entry permits only hosts in 10.1.2.0/24 to reach server 10.9.9.9 on HTTPS?
- Which feature prevents a rogue DHCP server on an access port from handing out addresses?
- Which statement correctly contrasts RADIUS and TACACS+?
- Which wireless security protocol introduced Simultaneous Authentication of Equals (SAE) to replace the PSK four-way handshake's weakness?